เครื่องกั้นบุคคลเข้าออก
-
เครื่องกั้นบุคคลเข้าออกแบบประตูหมุนสามขา KABA รุ่น TPB-E02
Standard measurements:
Product group: Special Doors
Width (mm): 770 mm
Height (mm): 1030 mm
Depth (mm): 1170 mm- Housing made of stainless steel satin finish AISI 304.
- non-tiltable crossbars made of stainless steel satinfinish AISI 304.
- variant A: passage side inwards right.
- Function Type 0 manual motion; mechanically free in one direction / opposite direction
- blocked. Locked direction of use: exit accessible, entry locked
- Electric Control system integrated in the unit.
- Power supply 100–240 VAC 50/60 Hz
- Doweled on finished floor level FFL, floor levelness according to DIN 18202 max. ± 2
- mm.
- Suitable for outdoor installation!
- Prot. class Housing IP33, components conducting supply voltage IP43.
-
เครื่องกั้นบุคคลเข้าออก KABA รุ่น Argus HSB-E11
Standard measurements:
Width (mm): 1070 mm
Height (mm): 945 mm
Depth (mm): 1290 mm- Passage width = 650 mm, total width = 1.070 mm, interlock height 945 mm,
- interlock length = 1.290 mm
- Guiding elements made of stainless steel AISI 304, Ø 60 mm, with 10 mm
- tempered safety glass panels and AISI 304 stainless steel bar handle.
- Integrated sensor system in respective handrail (L = 1290 mm / W = 130 mm / H =
- 45 mm).
- Two door leaves made of transparent polycarbonate, upper edge 900 mm.
- Drive housing made of stainless steel AISI 304.
- Stainless steel satin finish.
- Function Type 2 power assisted motion; 2 servo positioning drives / 2 directions electrically
- controlled, drives integrated in the rotating tube.
- Entrance sector monitored by a simple sensor system in short overall length
- (simple single passage monitoring in both directions, security level 0). Protective
- device: rotation angle of the door leaves is monitored by the same sensor system.
- operation mode:
- Default position “night-operation” closed: the door leaves open automatically for
- authorised persons in the passage direction and then close again after passage.
- In the case of a power failure: door leaves can be moved freely!
- Control units and power supply unit are integrated in the unit.
- Power supply 100-120 V / 200-240 V 50-60 Hz
- Dowelled on finished floor level FFL.
- Not suitable for outdoor installation!
- Suitable for escape routes if combined with emergency push button and escape
- route equipment (cf. general accessories).
-
เครื่องกั้นบุคคลเข้าออก KABA รุ่น Argus HSB-S05
Standard measurements:
Width (mm): 1070 mm
Height (mm): 945 mm
Depth (mm): 2010 mm- Passage width = 650 mm, total width = 1.070 mm, interlock height 945 mm,
- interlock length = 2.010 mm
- Guiding elements made of rectangular stainless steel posts AISI 304 with 8 mm
- tempered and satined safety glass panels and stainless steel bar handle AISI 304.
- Sensor system integrated in the guiding elements. The sensors are covered by the
- satined glass panels and infrared transmissible segments.
- Two door leaves made of transparent polycarbonate, upper edge 900 mm.
- Drive housing made of stainless steel AISI 304.
- Stainless steel satin finish.
- Function Type 2 power assisted motion; 2 servo positioning drives / 2 directions electrically
- controlled, drives integrated in the rotating tube.
- Entrance sector monitored by enhanced sensor system in optimised overall length
- and alignment (increased level of single passage monitoring in both directions,
- security level 2). Integrated protection against entry from below, identification of
- trolleys, detection of children. Protective device: rotation angle of the door leaves is
- monitored by the same sensor system.
- 2 operation modes are possible:
- Default position “day-operation” open: the door leaves close automatically if
- somebody tries to pass without authorisation
- Default position “night-operation” closed: the door leaves open automatically for
- authorised persons in the passage direction and then close again after passage
- In the case of a power failure: door leaves can be moved freely
-
เครื่องกั้นบุคคลเข้าออก KABA รุ่น Argus HSB-E07
Standard measurements:
Total width: 1070 mm
Passage width: 650 mm
Interlock height: 945 mm
Interlock length: 1660 mmDesign:
Guiding elements made of tubular AISI 304 stainless steel tubes Ø 60 mm with TSG 10 mm glass panel and AISI 304 hand rail. Two door leaves are made of transparent polycarbonate door leaves, thickness 10 mm, upper edge 900 mm.The sensor system is integrated into the respective hand rail (L= 1660 mm / W= 130 mm / H= 45 mm). The drive housing is made of AISI 304 stainless steel.
In case of multiple installations, the housing unit acts as a guiding element – additional guiding bars are not required. The passage width can be widened to 900 mm when necessary for passage or for passage of people with reduced mobility.
To improve personal safety, standards and guidelines relating to points where body parts could get pinched or squashed have been taken into account in the development of the sensor barrier (Machinery Directive 2006/42/EC).
